14 User Manual SATEL
2. Press the or key to enter the submenu (the key allows to exit the submenu) or
start the function.
5.3.3 Menu shortcuts
Support for the user menu shortcuts can be disabled by the installer.
You can use shortcuts for quick access to some menu elements (submenus, functions).
Press the suitable digit key (or combination of keys) to enter a submenu or start a function.
Shown below is the list of submenus and functions available by using shortcuts. The
shortcuts are shown in square brackets.
[1] Change own code
[2] Users
[21] New user
[22] Edit user
[23] Remove user
If the installer is not authorized to edit the users, the shortcuts beginning with the digit
2 will allow the installer to start the function from the MASTERS submenu.
[4] Zone bypasses
[41] Inhibit
[42] Isolate
[5] Events
[51] Selected events
[52] All events
[6] Set time
[7] System state
[8] Outputs control
[9] Service mode
[0] Downloading
[01] Start DWNL-RS
[02] Finish DWNL-RS
[03] Start DWNL-MOD.
[04] Start DWNL-TEL
[07] ETHM-1 – DLOADX
[08] ETHM-1 – GUARDX
5.3.4 Entering data by means of the LCD keypad
Data are saved to the control panel if you press the key (in some keypads, the key is
also available, whose function is exactly the same). The key enables exiting the function
without saving any changes.
Described below are general rules for entering data, however they may be different as
regards some functions.
Selection from the single-choice list
Shown in the upper line of display is description of the function, and in the lower one – the
currently selected item. You can scroll through the list of items, using the direction keys:
(down) and (up). The and keys are not used.
To Next Page
Loading...
