32 User Manual SATEL
– additional information on the events in shortened form, e.g. number of partition, zone,
user, timer, expander, keypad, etc.
Event description is displayed in the lower line.
If no key is pressed for a few seconds, additional information on the event will be displayed,
e.g. name of partition, zone, user, timer, expander, keypad, etc. After a few seconds, the
event description will be displayed again, and so on.
Pressing the key enables the manual toggling between description of the event and
additional information on the event.
Pressing the key when the event description is displayed will allow you to see further
additional information on the event, shown in a shortened form.
Using the or key will block the automatic toggling between description of the event and
additional information on the event.
After the list of events has been scrolled through with the use of the or key, the
automatic toggling between description of the event and additional information on the event
will be restored.
5.12 Programming the partition timer
The partition timer automatically arms / disarms the partition.
1. Enter the code and confirm with the
key
.
2. Using the key, scroll through the menu until you find the CHANGE OPTIONS submenu.
3. Press the
key
.
4. Using the key, scroll through the menu until you find the PART. TIMERS function.
5. Press the
key
. The list of partitions will be displayed.
6. Using the and keys, find in the list the partition for which the timer is to be
programmed.
7. Press the
key
.
8. When the ACTIVE option is displayed, make sure it is enabled (the
symbol is displayed
next to the option). If it is not enabled (the
symbol is displayed next to the option), press
any digit key.
9. Using the key, scroll through the menu until you find the TYPE function.
10. Press the
key
.
11. Using the and keys, select the timer type:
everyday – if the partition is to be armed / disarmed at the same time every day,
weekly – if the partition is to be armed / disarmed at different times on different days of
the week.
12. Press the
key
.
13. If you have selected the daily variant, the function will allow you at once to program the
arming time, and upon pressing the or key – the disarming time. Upon confirmation
with the
key, you will be brought back to the list of options and functions.
14. If you have selected the weekly variant, you will be brought back to the list of options and
functions, where functions will appear to enable programming of the arming / disarming
time for each day of the week (in the same way as for daily timer).
Programming the value 99:99 means that the partition will not be armed / disarmed.
15. After the arming time has been programmed, an additional function will be displayed,
which allows you to define which arming mode will be activated by the given timer. By
default, the timer activates the full arming mode. If another arming mode is to be
To Next Page
Loading...
