Satel PERFECTA - Codes and Event Signaling; System Access Codes; Event Signaling Beeps

SATEL PERFECTA 9
– turning off the CHIME in the keypad, using the key,
– switching over the display from the normal mode to the zone status presentation mode,
and vice versa, by means of the key.
4 short beeps and 1 long beep – confirmation of:
– turning output on,
– turning on the CHIME in the keypad, using the key.
2 long beeps – incorrect code or pressing the key, if not preceded by entering code or
selecting a partition.
3 long beeps – refusal to carry out a command (the user does not have the required
authority level or the function is not available).
Beeps generated during programming
1 short beep – pressing any number key.
2 short beeps – entering the user menu, submenu or starting a function.
3 short beeps – exiting the service function on pressing the key.
4 short beeps and 1 long beep – termination of the user function on pressing the key,
or quitting the service mode.
2 long beeps – exiting the function on pressing the key, or an unavailable function.
Event signaling
Only installer selected events are signaled.
Duration of the alarm signaling is to be defined by the installer.
If the GRADE 2 option is enabled by installer, the keypad will not signal by sounds any
troubles and alarms.
5 short beeps – zone violation (CHIME).
Long beep every 3 seconds, followed by a series of short beeps for 10 seconds
and 1 long beep – countdown of exit delay (if the time is shorter than 10 seconds, only
the final sequence of short beeps will be generated).
2 short beeps every seconds – countdown of entry delay.
2 short beeps every 3 seconds – signaling a trouble.
Short beep every 0.5 seconds – warning alarm.
Continuous beep – alarm.
Long beep every second – fire alarm.
6.2 Codes
Operating the alarm system by means of the keypad is possible after entering the code. Only
some functions can be run without the code being entered.
Do not make your code available to other people.
Using an incorrect code three times may block the keypad for 90 seconds.
6.2.1 Factory default codes
By default, the following codes are preprogrammed in the control panel:
user 15 code: 1111
service code: 12345