Satel PERFECTA - Zone Bypassing and Outputs Reset; Outputs Reset Functionality; Zone Inhibiting Procedure

18 PERFECTA SATEL
1. Press to run 5.REMOV.KEY FOB function.
2. Type and serial number of the keyfob being removed will be displayed.
3. Press to remove the keyfob.
6.10 Outputs reset
Using 3.OUTPUTS RESET function you can:
 deactivate 1. EXTERNAL SIREN, 2. INTERNAL SIREN, 3. BURGLARY, 4. FIRE ALARM, 5. DURESS
ALARM
, 6. PANIC ALARM, 7. AUX. ALARM, 8. ALARM – NOT VERIFIED, 9. ALARM - VERIFIED,
E DETECTORS POWER SUPPLY function output (to clear
SET
ss
10. T
AMPER ALARM, 13. ZONE VIOLATION and 14. CHIME function outputs,
 deactivate for 16 seconds the 11. FIR
the alarm memory of fire detectors),
 activate the 21. D
ETECTORS RE function output.
Enter the user menu and pre to run 3.OUTPUTS RESET function.
6.11 Zone bypassing
If a zone is not to trigger alarm, you can bypass it, when the partition to which the zone
belongs is disarmed. Zone bypassing is useful, for example, when you want to leave
a window open when the system is armed or when a detector connected to the zone is out of
r a
y enable
nd sets off false alarms.
Zone bypassing reduces the level of protection. When bypassed, the zone ma
orde
the intruder to get inside the protected area despite the system being armed.
If a zone is bypassed because of its malfunctioning, call in the service technician
immediately to repair the defect.
For security considerations, the installer may reduce the number of zones that the user
will be allowed to bypass.
The zone bypassing functions can also be used to unbypass the zones (the zone inhibiting
function makes it also possible to unbypass an isolated zone, while the zone isolating
ible to unbypass an inhibited zone).
assed until disarming the part
ition it belongs to, or until
yp
n both partitions are armed,
function makes it also poss
6.11.1 Zone inhibiting
The inhibited zone will remain byp
assing the zone by the user.
If the zone belongs to two partitions and is only armed whe
unb
it will be unbypassed after disarming one of the partitions.
1. Enter the user menu and press in turn to run 1.INHIBIT function.
2. The list of zones will be displayed. You can scroll the list using the and keys.
There is a symbol in the upper right corner of the display:
– zone is not bypassed,
– zone is inhibited,
– zone is isolated.
3. Press any number key to change the displayed symbol to one of the following symbols:
– the zone is to be inhibited,
– the zone is to be unbypassed.