Satel PERFECTA - User and System Management; Changing User Codes; Outputs Reset Function

SATEL PERFECTA 15
3.Partitions selecting supported partitions
fob
key fob
● run with buttons ○+●
nt
ite keyfob use to event log
ve user removing a user
3.Ou uts / activating 21. DETECTORS RESET output
4.Zon
Inhibit
.Isolate
s / 7.System state checking troubles / checking system status
8.Ou uts
9.Tes
signal level
t
MEI/ID checking the IMEI number / ID number
of devices
0.SIM
1 PUK code
PUK code
rules
establishing communication with PERFECTA SOFT via GPRS
starting service mode
4.Add key
adding keyfob
5.Remov. removing keyfob
Button ○ selecting function to run with button ○
Button □ selecting function to run with button □
Button ▲ selecting function to run with button ▲
Button ■ selecting function to run with button ■
Button ● selecting function to run with button ●
Button
○+ selecting function to
Key fob eve
do you want to wr
8.Name editing user name
[23] 3.Remo
tputs reset deactivating outp
e bypasses
[41] 1. inhibiting zones
[42] 2 isolating zones
5.Event log viewing events
6.Set time setting the clock
7.Trouble
tputs ctrl. controlling the outp
ts
[91] 1.Zones test starting zone test
[92] 2.Outputs test starting output test
[93] 3.Signal level checking GSM / radio
[94] 4.Test even starting manual test transmission
[96] 6.ID change
changing existing ID
[97] 7.I
[98] 8.FW
versions
checking firmware version
cards
[01] 1.SIM1 credit
SIM1 card account status
[02] 2.SIM2 credit SIM2 card account status
[03] 3.Top up SIM1 topping up SIM1 card account
[04] 4.Top up SIM2 topping up SIM2 card account
[05] 5.SIM entering PUK code SIM1 card
[06] 6.SIM2 entering PUK code SIM2 card
Service access defining service access
PERFECTA Soft
Service mode
6.8 Changing code
1. Enter the user menu and press to run 1.CHANGE CODE function.
2. Enter the new code.
3. Press
to save new code.