20 PERFECTA SATEL
6.14 Checking the troubles / system state
When the LED is blinking, check what is the cause of this signaling. Enter the user menu
and press . To scroll the list, use the and keys.
rmation on system state
is enabled by the installer, the 7.SYSTEM STATE function, instead of the
unction, is available in the user menu. When the function is running, the
partition status (disarmed or arming type).
ble memory and clearing the trouble memory
the current troubles are to be presented, or also those
r of the display
6.14.1 Info
If the GRADE 2 option
7.TROUBLES f
following information is displayed:
alarms,
bypassed zones,
troubles,
6.14.2 What to do in the event of trouble
Each trouble poses a danger to proper functioning of the alarm system and should be
repaired as soon as possible. If necessary, consult the installer.
6.14.3 Trou
The installer defines whether only
which have already ended. The flashing letter “M” in the upper right corne
means that the trouble has already ended. You can clear the trouble memory after quitting
the function.
1. Press to quit the func
2. The “Clear trouble mem
tion.
ory? 1=Yes” message will appear on the display.
3. Press to clear the trouble memory (press , if you don’t want to clear the trouble
memory).
6.15 Output control
Using the keypad, you can control the operation of devices connected to the outputs (e.g. to
utputs
(the ontrollable outputs
must be assigned to the keys designated with digits). If the quick control is available, you can
to the outputs without having to enter the code.
then
raise/lower
roller blinds/shutters, turn on/off lighting or heating, etc.). The installer defines
how the outputs should work (whether the output will be activated for a defined time, or it will
remain active until deactivated by the user, timer, etc.).
6.15.1 Quick control of o
Consult the installer whether the quick control of outputs is available c
turn ON/OFF devices connected
Quick activation of output
Press the key to which the controllable output is assigned, and .
Quick deactivation of output
Press the key to which the controllable output is assigned, and then .
6.15 puts by means of function
1. Enter the user menu and press
.2 Controlling the out
to run 8.OUTPUTS CTRL. function.
2. Symbols illustrating the status of outputs you can control will be presented in the upper
line of the display:
– output is deactivated,
To Next Page
Loading...
