Satel PERFECTA - System Tests; Zone and Detector Testing; Output and Siren Testing; GSM;Radio Signal Check

SATEL PERFECTA 21
– output is activated.
The numbe
displayed b
rs above the display make identification of the outputs possible. If no symbol is
elow the number, you cannot control the output.
3. Use the or key to hover the cursor over the output you want to control. The
ut will be presented in the lower line of the display. name of the outp
4. Press to activate the output or to deactivate the output.
Tests 6.16
6.16.1
The 1. to test the system zones and detectors.
Zone test
ZONES TEST function allows you
You can test the zones for which the installer has programmed other wiring type than
NO DETECTOR.
Zone violation during the test will not trigger the control panel reaction, as
preprogrammed for the zone.
When testing the zones, the keypad does not present the current zone state, but only
indicates whether or not the zone was violated during the test.
1. Enter the user menu and press in turn to run 1.ZONES TEST function.
2. Define the test duration (from 1 to 99 minutes).
3. Press to start test.
4. The zones that you can test will be presented on the display by the symbol . The
gh the area supervised by the motion detector or
supervised by the magnetic contact).
numbers around the display enable identification of the zones.
5. Violate the zone (e.g. walking throu
opening the window
6. The keypad should inform you that the zone has been violated (the zone symbol changes
to ). Information on the violation will be presented until the zone test is terminated.
7. The test will be terminated automatic lly after the defined time has elapsed. Ya ou can
terminate it earlier by pressing .
6.16.2 Output test
The ction makes it possible to test the system outputs and sirens or other
devices connected to the outputs.
1.
2.OUTPUTS TEST fun
Enter the user menu and press in turn
to run 2.OUTPUTS TEST function.
Symbols illustrating the status of outputs you can test w2. ill be presented in the upper line
of the display:
– output inactive,
– output active.
The numbers above the display make identification o
displayed below the number, you cannot test the out
f the outputs possible. If no symbol is
put.
3. Use the
or key to hover the cursor over the
of the output will be presented in the lower line of
output you want to test. The name
the display.
4. Press
to activate the output or to deactivate the output.
6.16.3 Checking the level of GSM / radio signal
Using the 3.SIGNAL LEVEL function you can check:
 the level of signal received by the GSM antenna,