Satel PERFECTA - Arming Procedures; Arming Without Partition Selection; Arming Selected Partitions; Quick Arming Method

10 PERFECTA SATEL
The factory default codes should be changed before you start using your alarm
system (see: “Changing code”).
6.3 Arming
Completion of the steps below will start the arming procedure. The procedure ends when the
exit delay time elapses (if the countdown is completed successfully, the system becomes
armed – see also “Failure of arming procedure”). If the exit delay time is 0, the system
becomes armed instantly.
The day/night arming modes are available if the installer has defined which zones are
to be active in this armed mode.
During the exit delay countdown, you can leave the partition through the exit route
without triggering alarm.
6.3.1 Arming without partition selection
Enter the code, and then press:
- to arm in full mode,
- to arm in day mode,
- to arm in night mode.
In the partitions you have access to, the arming procedure will begin.
6.3.2 Arming the selected partition
1. Select the partition which is to be armed (press one of the keys: - partition 1; -
partition 2).
2. Select the arming mode (press one of the keys: - full arming; - day arming;
- night arming). Backlight of the keys will start blinking, which indicates that the code
must be entered.
3. Enter the code.
4. Press
or press again the key corresponding to the selected arming mode.
5. In the selected partition, the arming procedure will begin.
When the quick arming is available, the steps 3 and 4 are skipped.
6.3.3 Quick arming
The installer may permit arming without entering the code.
1. Indicate the partition(s) to be armed (press one of the keys: - partition 1; -
partition 2; or - both partitions).
2. Select the arming mode (press one of the keys: - full arming; - day arming;
- night arming).
3. In the partition(s), the arming procedure will begin.
6.3.4 Arming without delay
If there is nobody in the partition or nobody is leaving the partition which is to be set to the
day / night armed mode, you can arm the partition without exit delay (there will be no beeps
accompanying the exit delay countdown). When setting the partition to one of the above-
mentioned armed modes, hold down the armed mode selection key (
, or ) for
about 3 seconds. The exit delay countdown will not run.