SATO CL6NX - Page 98

98
[Barcode darkness] (PW208NX/PW208mNX only)
Currentlynotsupported.
[Barcode darkness range] (PW208NX/PW208mNX only)
Currentlynotsupported.
O󰀨set
[Top]
You can adjust the print base reference point in vertical direction (the height
directionofthemedia).
[Left]
You can adjust the print base reference point in horizontal direction (the width
directionofthemedia).
Advanced Settings (CL4NX/CL6NX/CL4NX Plus/CL6NX Plus/CT4-LX/FX3-LX/
PW4NX/S84NX/S86NXonly)
[Send static elements only on rst page (Overlay function)]
Allstaticelementswillbesenttoonlytherstpageoftheprintjob.Onlyvariable
elementswillbesentforsubsequentpages.Staticelementsarecalledfromprinter
memory.
[Set xed document length for continuous label]
Sendtheentirelabeltoanappropriatepositionaftertheprinternishesprinting.
Foracontinuouslabel,theonelabelisthefeedamountbecausethefeedamount
cannotbedeterminedbythesensor.
[Non-standard protocol output]
SubstituteandoutputpartofthecontrolcodeasASCIIreadablecharacters.This
featureisforhostenvironmentsthatcannotusebinarydata.
[Use legacy calendar print command] (CL4NX/CL6NX/CL4NX Plus/CL6NX Plus/
CT4-LX/FX3-LX only)
Thisworkswhenlinkedwith"NiceLabel”oftheapplication.Ifchecked,[ESC+WA]
isusedasthecalendarprintcommand,andifunchecked,[ESC+WU]isused.
[Use legacy RFID locking command] (CL4NX/CL4NX Plus/CL6NX Plus/CT4-LX/
S84NX/S86NX only)
SelecttheformatoftheRFIDlockingcommand.Ifchecked,thelegacy"lck"format
RFIDlockingcommandisused,andifunchecked,the"lc2"formatRFIDlocking
command is used.