SECTION 2: INSTALLATION AND SETUP
Page 2-32 SATO HT200e
PROCESS ON THE SCREEN FOR VOLTAGE INDICATION OF CARD BACKUP
MEMORY
9 + Power “ON”
[
←
][
→
]
[
←
][
→
]
[
←
][
→
]
[PGUP] [ENTR]
Note: Where card is not connected, there can not be seen any descriptions in the second line. For Service
Maintenance Mode, FULL/EMPTY can be made available for the voltage indication of card back-up
memory. The voltage can not be displayed. Whether the voltage is FULL or EMPTY will become available
for the back-up memory when power is applied.
ＴＥＳＴ ＰＲＩＮＴ
1
ＢＡＴＴＥＲＹ ＣＨＥＣＫ
2
ＲＡＭ ＢＡＣＫ ＢＡＴＴＥＲＹ
3
ＣＡＲＤ ＢＡＴＴＥＲＹ
4
ＣＡＲＤ ＢＡＴＴＥＲＹ
ＢＡＴＴＥＲＹ ＦＵＬＬ
Press [ENTR], so that it displays voltage in battery.
Press [
←
], so that it returns to the process No. 1.
Press [
→
] , so that it goes to the process No. 3.
Press [ENTR], so that it starts test print.
Press [
→
], so that it goes to the process No. 2.
Press [ENTR], so that battery level (or remaining
fuel) can be indicated for RAM’s back-up.
Press [
←
], so that it returns to the process No. 2.
Press [
→
], so that it goes to the process No. 4.
Press [ENTR], so that battery level (or remaining
fuel) can be indicated for card’s back-up.
Press [
←
], so that it returns to the process No. 3.
Press [PGUP], so that it returns to the screen for the
selection of battery level indication for cards
back-up.
To Next Page
Loading...
