SATO HT200e - Page 91

SECTION 4 ： FREE MODE
Page 4-28 SATO HT200e
It will go to the entry for copy.
０１ １１ : ＣＨＡＲ ＰＩＴＣＨ
7
７０１０２５０３２０
２ ０００００
０１ １２ : ＣＨＡＲ ＣＯＵＮＴ
8
７０１０２５０３２０２
０ ００００
０１ １４ : ＢＡＲ ＲＡＴＩＯ
9 ０ : ＦＩＸＥＤ １ : １―２ ▽
７０１０２５０３２０２０８
０ ００
０１ １５ : ＢＡＲ ＥＸＰＡＮＳ
10
７０１０２５０３２０２０８１
０ ０
０１ １６ : ＢＡＲ ＨＥＩＧＨＴ
11
７０１０２５０３２０２０８１１
０
０１ １９ : ＣＨＥＣＫ ＤＧＴ
12 ０ : ＯＦＦ １ : ＯＮ ▽
８５
０ ０００００００００００
０１ ２０ : ＰＲＥＳＥＴ
13 ０ : ＯＦＦ １ : ＯＮ
８５１
０ ００００００００００
０１ ２１ : ０ ＲＥＳＥＲＶＥＤ
14
８５１０
０ ０００００００００
Value in 2 digits can be entered for the number of
characters: Select the values from “01” to “22”.
Value in one digit can be entered for the bar ratio:
Select the value from “0”, “1”, “2”, and “3”.
Value in one digit can be entered for the bar ratio:
Select the value from “2”, “3”, and “4”.
Value in 3 digits can be entered for the bar height:
Select the values from “001” to “240”.
Value in one digit can be entered for the check digit:
Select the value from “0”, “1”, “2”, and “3”.
Value in one digit can be entered for preset:
Select “0” or “1”.
Value in one digit can be entered for spacing between
characters in human readable information: Select the
value from “0” to “9”.
“0” is fixed.