SATO TH2 Series - Page 118

Section 6: Basic Specifications
Page 6-2 TH2 Series Operator Manual
6.1 PRINTER BASIC SPECIFICATIONS (Cont’d)
MEDIA (Be sure to use media manufactured or certified by SATO)
Size
Die cut label
Continuous
Cutter
Tear-off
Dispenser
Width: 25 to 60 mm (0.9” to 2.3”)
Width including liner: 28 to 63 mm (1.1” to 2.4”)
Pitch: 16 to 156 mm (0.6” to 6.1”)
Pitch including liner: 19 to 159 mm (0.7” to 6.2”)
Width: 25 to 60 mm (0.9” to 2.3”)
Width including liner: 28 to 63 mm (1.1” to 2.4”)
Pitch: 16 to 156 mm (0.6” to 6.1”)
Pitch including liner: 19 to 159 mm (0.7” to 6.2”)
Width: 25 to 60 mm (0.9” to 2.3”)
Width including liner: 28 to 63 mm (1.1” to 2.4”)
Pitch: 16 to 156 mm (0.6” to 6.1”)
Pitch including liner: 19 to 159 mm (0.7” to 6.2”)
Width: 25 to 60 mm (0.9” to 2.3”)
Width including liner: 28 to 63 mm (1.1” to 2.4”)
Pitch: 16 to 117 mm (0.6” to 4.6”)
Pitch including liner: 16 to 120mm (0.6” to 4.7”)
Butt-cut label
Continuous
Tear-off
Dispenser
Width: 25 to 60 mm (0.9” to 2.3”)
Width including liner: 28 to 63 mm (1.1” to 2.4”)
Pitch: 16 to 156 mm (0.6” to 6.1”)
Pitch including liner: 19 to 159 mm (0.7” to 6.2”)
Width: 25 to 60 mm (0.9” to 2.3”)
Width including liner: 28 to 63 mm (1.1” to 2.4”)
Pitch: 16 to 156 mm (0.6” to 6.1”)
Pitch including liner: 19 to 159 mm (0.7” to 6.2”)
Width: 25 to 60 mm (0.9” to 2.3”)
Width including liner: 28 to 63 mm (1.1” to 2.4”)
Pitch: 16 to 117 mm (0.6” to 4.6”)
Pitch including liner: 16 to 120 mm (0.6” to 4.7”)
Linerless label
* The size may be limited by
use conditions.
without cutter
with cutter
Width: 28 to 60 mm (1.1” to 2.3”)
Pitch: 25.4 to 100 mm (1” to 3.9”)
Width: 28 to 60 mm (1.1” to 2.3”)
Pitch: 45 to 100 mm (1.7” to 3.9”)
Type
Direct Thermal
Use roll media specified by SATO.
Roll Diameter Maximum outer diameter: 75 mm (2.9”)
Core Diameter
Inner core diameter: 26 mm(1.0”),
depending on media type
Thickness 0.14 to 0.19 mm (0.006” to 0.007”).
Wind Direction Face-out or Face-In