Section 8: Appendix
TH2 Series Operator Manual Page 8-3
8.1 OPTIONAL ACCESSORIES - CUTTER (cont’d)
8.1.3 Cutter replacement
Over time, the cutter loses its cutting ability and begins to show
signs of wear.
Replace the cutter unit when the blade becomes blunt and cut
edges are rough. (Please contact an authorised SATO
representative for replacement.)
8.2 POSITIONS OF SENSORS AND OPTIONS
14mm~31.5mm (0.55”~1.24”)
Gap sensor
I-Mark sensor
35.3mm
(1.39”)
14.7mm
(0.58”)
17.1mm
(0.67”)
Print head
Dispenser/
Tear-off
Cutter
3.5mm~21mm
(0.14”~0.82”)
To Next Page
Loading...
