SATO TH2 Series - Wireless LAN Settings

Section 7: Interface Specifications
Page 7-6 TH2 Series Operator Manual
7.3 LOCAL AREA NETWORK (LAN) ETHERNET AND WIRELESS LAN (cont’d)
7.3.5 Setting/Displayed Items
The following table shows the settings and referable sections as well as various variables.
TCP/IP related settings
7.3.6 Wireless LAN Setting
Variable identifier Default (Factory setting) Setting range
IP address 0.0.0.0 (Externally obtained) 0.0.0.0 ~ 255.255.255.255
Subnet mask 0.0.0.0 (Derived from IP address) 0.0.0.0 ~ 255.255.255.255
Gateway address 0.0.0.0 (Invalid) 0.0.0.0 ~ 255.255.255.255
RARP protocol DISABLED ENABLE/DISABLE
DHCP protocol ENABLE ENABLE/DISABLE
ROOT password NULL (No password) Up to 16 alphanumeric characters
Name server 0.0.0.0 (Default) 0.0.0.0 ~ 255.255.255.255
Item Default Setting range
WLAN Mode 2
1: Infrastructure (use SSID)
2: Ad hoc
SSID “SATO” 1 ~ 32 characters(*4)
Channel 11 1 ~ 11(*2)
WLAN Authentication 0
0: Open System
1: Shared Key
Security Mode 0
0: Not used
1: WEP
2: WPA
3: WPA2
4: DynamicWEP
Configure WEP Key
(Set this item when
encrypting with WEP
key)
WEP Key1 “”(NULL)
40 bit WEP:(*1)
5 characters
10-digit HEX code
104 bit WEP:
13 characters
26-digit HEX code
WEP Key2 “”(NULL)
WEP Key3 “”(NULL)
WEP Key4 “”(NULL)
WEP Key Index 1 1 ~ 4
Configure WPA
(Set this item when using
WPA/WPA2)
WPA Authentication 0
0: PSK
1: EAP(IEEE802.1X)
WPA PSK Mode 0
0: TKIP
1: AES
WPA PSK “”(NULL) 8 ~ 63 characters(*4)