Safety Precautions
Page ii TH2 Series Operator Manual
Warning
Regarding the cutter
• Do not touch the cutter with
your hands or do not put
something into the cutter.
Doing so could result in an
injury.
Using the head cleaning fluid
• Use of flame or heat around
the head cleaning fluid is
prohibited. Absolutely do not
heat it or subject it to flames.
• Keep the fluid out of reach of
children to prevent them from
accidentally drinking it. If the
fluid is drunk, immediately
consult with a physician.
Battery Pack
• Never try to take apart the
battery pack or modify it in any
way such as with a solder iron.
• Never expose the battery to
direct flame, throw it into fire,
or take any actions that may
lead to shorting.
• When charging the battery
pack, make sure to use the
printer or specified battery
charger.
AC Adapter/ Battery Charger (Option)
• Use only the specified voltage.
Using a different voltage may
create the danger of fire or
electric shock.
• Use only the specified AC
adapter. Using a different one
may create the danger of fire
or electric shock.
• Never use the battery charger
with any other battery pack
except for the specified one.
Doing so can rupture the bat-
tery, cause leakage, fire or
electric shock.
Caution
Do not place in areas with high
humidity
• Do not place the printer in
areas with high humidity or
where condensation forms. If
condensation forms,
immediately turn off the power
switch and do not use the
printer until it dries. Using the
printer while condensation is
on it could result in electric
shock.
Carrying the Printer
• When moving the printer,
always unplug the power cord
from the outlet and check to
make sure all external wires
are disconnected before
moving it. Moving the printer
with the wires still connected
could damage the cords or
connecting wires and result in
a fire or electrical shock.
Top cover
• Be careful not to get your
fingers pinched when opening
or closing the top cover. Also
be careful the top cover does
not slip off and drop.
Power supply
• Do not operate the power
switch or plug in/unplug the
power cord with wet hands.
Doing so could result in
electric shock.
Power cord
• Keep the power cord away
from hot devices. Getting the
power cord close to hot
devices could cause the cord’s
covering to melt and cause a
fire or electrical shock.
• When unplugging the power
cord from the outlet, be sure to
hold it by the plug. Pulling it by
the cord could expose or
break the core wires and
cause a fire or electric shock.
• The power cord set that
comes with the printer is
especially made for this
printer. Do not use it with any
other electrical devices.
Replacing the Rechargable Battery
Pack
• Use only the specified battery
pack.
• When replacing the battery
pack, make sure to install the
pack in the correct orientation.
Incorrectly replacing the
battery creates the danger of
explosion, injury or damage to
surrounding areas.
Lithium coin battery
• Risk of explosion if battery is
replaced by an incorrect type.
• Apply insulation treatment for
the used battery by sealing the
contact with tape or the like
and dispose it according to the
local safety regulatory.
Print head
• The print head is hot after
printing. Be careful not to get
burned when replacing paper
or cleaning immediately after
printing.
• Touching the edge of the print
head immediately after printing
could result in injury. Use
caution when replacing the
label or cleaning the print
head.
• You should not replace the
print head without having
received the proper training.
Loading paper
• When loading roll paper, be
careful not to get your fingers
pinched between the paper roll
and the supply unit.
When not using the printer for a long
time
• When not using the printer for
a long time, unplug the power
cord from the outlet to
maintain safety.
During maintenance and cleaning
• When maintaining and
cleaning the printer, unplug the
power cord from the outlet to
maintain safety
To Next Page
Loading...
Need help?
General
