1. DRIVING TEST
2. DRIVING TEST (POCR)
3. FEEDING TEST
In this mode, you can have a test if the machine detects the
input of key. Every time you press a key, the name of the key
will be displayed on LCD. However, in case of CLEAR key,
you exit from the current menu in stead of displaying.
1) Driving Test
You can run Main and Feed Motor in various speeds.
2) Driving Test (POCR)
You can run Main and Feed Motor in low speed.
3) Feeding Test
You can input notes (More than 5 notes) and test the speed
of each level. (Speed: LOW, 1000, 1200, 1500 NPM)
The speed of Wing Stacker can change fast or slow (“±10”) by
pressing UP/DOWN key and press “START: key to save it.
To exit from current menu, press 9(menu) key.
RED LED on the right of Front OPE lights and Selector sends the
notes to stacker.
2) Selector Rejecter
RED LED on the right of Front OPE is turned off and Selector
sends the notes to Rejecter.
After you push the “start” button, and press 9(menu) key, you
can exit from the current menu.
2. KEY TEST
3. MOTOR TEST
4. SELECTOR TEST
5. WING SPEED SETTING
To Next Page
Loading...
