Scanreco RC400 G3B - 10.3.4 Position 04 - Micro speed SET1; 10.3.5 Position 05 - Start ramp SET1; 10.3.6 Position 06 - Stop ramp SET1; 10.3.7 Position 07 - Start speed SET2

10.3.6 Position 06 - Stop ramp SET1
10.3.7 Position 07 - Start speed SET2
10.3.8 Position 08 - Stop speed SET2
For individual adjustment of stop ramp
Available values:
Valuesrangingfrom0-100(0=Norampdelay,1-50=x100msdelay/step)
When activating a lever/joystick the LED-display will indicate which output that is active and its
corresponding stop ramp speed.
For individual adjustment of start speed
Available values:
Values ranging from 1-100
When activating a lever/joystick the LED-display will indicate which output that is active and its
corresponding start speed.
For individual adjustment of stop speed
Available values:
Values ranging from 1-99
When activating a lever/joystick the LED-display will indicate which output that is active and its
corresponding stop speed.
10.3.9 Position 09 - Micro speed SET2
For individual adjustment of 1st step micro speed
Available values:
Values ranging from 1-100
When activating a lever/joystick the LED-display will indicate which output that is active and its
corresponding 1st step micros speed.
10.3.5 Position 05 - Start ramp SET1
For individual adjustment of start ramp
Available values:
Valuesrangingfrom0-100(0=Norampdelay,1-50=x100msdelay/step)
When activating a lever/joystick the LED-display will indicate which output that is active and its
corresponding start ramp speed.
10.3.4 Position 04 - Micro speed SET1
For individual adjustment of 1st step micro speed
Available values:
Values ranging from 1-100
When activating a lever/joystick the LED-display will indicate which output that is active and its
corresponding 1st step micros speed.
Example:
4:b – 6:0 meaning micro speed is set to 60% of maximum velocity on output 4B.
Document type Document number PageRev
Service Manual S071 C 38 of 46