Chapter 2: Scanner Basics
Lamps
38 Scantron
i
NSIGHT 20 Scanner
Lamps
Default Lamp Shut Off Period
The default shut off period for the lamps is 15 minutes.
The iNSIGHT 20 scanner reverts to this default each time
it is powered up.
Software Lamp Warm Up and Shut Off Periods
Lamp warm up and shut off periods vary depending on
the software that you are using. See the table below:
NOTE:
If you wish to shut off the lamps sooner than 240
minutes after running a ScanTools Plus application,
simply run Click&Scan or SVT with the Power Saver
Device Setting set to the desired shut off time.
Software Warm up Shut off
• ScanTools Plus
• associated data collec-
tion diagnostic software
5 minutes 240 minutes
• Click&Scan
• Scanner Validation Tool
(SVT) document imag-
ing software
10 seconds 0 to 240 minutes based
on Power Saver setting
in Device Settings
To Next Page
Loading...