Chapter 4: Maintenance
Removing and Replacing the Feed Module
Operator’s Guide 105
Removing and Replacing the Feed Module
Degradation of feeder performance, multiple feeds,
stoppages, etc. indicate a need to change the feed module.
Certain paper types such as carbonless paper or newsprint,
or failure to clean regularly, and/or use of non-
recommended cleaning solvents can shorten the feed
module life.
NOTE:
The paper present sensor is located to the right of
the feed module. Be careful not to damage the paper
present sensor when removing or cleaning around the
feed module.
1. Remove the input tray by gently pushing it to the left
or right to release the pin from the slot, and lift it out
of position.
To Next Page
