Chapter 4: Maintenance
Maintenance Schedule
84 Scantron
i
NSIGHT 20 Scanner
NOTE:
Scantron scanners use replaceable tires than can feed
a wide range of document types, sizes and thicknesses.
Tire life and performance will vary based on the
document set, the frequency of cleaning of the
transport and tires, and following the recommended
schedule for changing tires. You should change the
tires if you notice an increase in multiple feeds,
stoppages, or a decrease in feeder performance that is
not resolved by the above cleaning procedures.
NOTE:
Certain paper types (such as carbonless paper or
newsprint), failure to clean regularly, and/or use
of non-recommended cleaning solvents can shorten
tire and roller life.
Clean paper path Daily Use emulsiclean wipe, (part
number 137 4966) in transport
area and on red and white
rollers. Allow to air dry.
CAUTION:
DO NOT USE THE
EMULSICLEAN WIPE
ON THE GRAY FOAM
TIRES.
Replace (separator
module and feed
module) tires
Every 100,000
documents scanned
Use tires from feed roller kit
(part number 832 0806) or
consumables kit (part number
20190).
Replace separator
module
Every 200,000
documents scanned
Use separation module, (part
number 186 0089).
Replace pre-separation
pad
Every 250,000
documents scanned
Use part from feed roller kit
(part number 832 0806).
Replace feed module Every 500,000
documents scanned
Use feed module (part number
192 9991).
Procedure Interval What to Use
To Next Page
Loading...
