Installation and operating instructions
23 Vers. 1.0 2024_03
3.3 Identification
Each luminaire unit has a unique identification number, which is provided to the controller
during production and cannot be modified. The ID can be read from the sticker above the
terminal block, after “SL” (8 numbers and letters). When installing, it must be noted on the
blueprint and installation booklet for accurate identification.
Each luminaire also has a drawing mark that identifies the luminaire to the user. It can typically
be divided into 4 segments, e.g.: 1/1/2/5, in this case the luminaire 5 of group 2 located on
circuit 1 of control panel 1.
Setup booklet
With a pre-filled setup booklet, we can make things easier for installers. The installation booklet
is available in editable EXCEL format, one copy of each panel should be filled out.
To Next Page
Loading...