Scientifica MDU - Page 9

Page 9 of 58
Above-
stage
variant
(Manual
Objective
Changer)
 One main optics module fitted with objective slide
guide rails and either
o One PMT module (rear position) and One
blanking plate (side position) or
o Two PMT modules.
 One or Two signal cables (3.5 metres RG174
Coax, SMA to BNC with 50 –Ohm terminations).
 Two objective slides
 Adaptor rings for objective sliders: M25, M27 &
RMS
 One Support bracket (factory fitted)
 Two M5 X 25 mm bolts for attaching to the
SliceScope
 One kit of Allen keys, including one 4 mm ball-
ended driver for the main attachment bolts.
 Two transit caps (upper and lower)
 One set of telescopic tubes (two pieces)
 One U-MF2 Olympus filter cube (un-populated)
 One 1U rack-mount two-channel controller unit
(without rack mounting screws)
 One universal mains to 12V DC power supply,
low noise, with 2.5 mm DC barrel plug.
 One user manual.
 One mixed pollen grain slide (2P test target)
Above-
stage
variant
(MOC)
 One Motorised Objective Changer (MOC) fitted
with specific DIC prism holder and shroud.
 One specific mounting bracket (pre-assembled)
 One main optics module fitted with either
o One PMT module (rear position) and One
blanking plate (side position) or
o Two PMT modules.
 One or Two signal cables (3.5 metres RG174
Coax, SMA to BNC with 50 –Ohm terminations).
 Two M5 X 30 mm bolts for attaching to the
SliceScope
 One Kit of Allen keys, including one 4 mm ball-
ended driver for the main attachment bolts.
 One transit cap (upper only)
 One set of telescopic tubes (two pieces)
 One U-MF2 Olympus filter cube (un-populated)
 One 1U rack-mount two-channel controller unit
(without rack mounting screws)
 One universal mains to 12V DC power supply,
low noise, with 2.5 mm DC barrel plug.
 One user manual.
 One mixed pollen grain slide (2P test target)
Sub-stage
variant
 One sub-stage specific main optics module fitted
with condenser adapter plate and either
o One PMT module (rear position) and One
blanking plate (side position) or
o Two PMT modules.
 One or Two signal cables (3.5 metres RG174
Coax, SMA to BNC with 50 –Ohm terminations).