The installation is then controlled via the automatic systems in accordance with the configuration of the application:
inversion of normal/emergency source
grid coupling
etc.
Tests
If no faults are present, automatic mode can be activated by pressing
uto.
The test starting phase is then initiated after pressing
1 on the test keypad.
Pressing
1 on the test keypad brings up the following window for selecting the test type.
15/07/09 19 : 10 :00 GS 1 Operation Manu Faults Alarms
I1(A) 2701 F.P 0,9 L
Q (kVAr)
Speed (rpm) 1505
765
Operating time: 10 :05
+ Speed - Speed + U -U
- 1 -
Function keys
- 2 -
Synchronisation column
- 3 -
Power plant
measurements summary
Using the KERYS Tactil Man-Machine Interface, the under
load test is started by pressing the corresponding key.
Using the KERYS Tactil Man-Machine Interface, the off load
test is started by pressing the corresponding key.
Test selected
Select the test to be carried out
Under load
test
Esc
No load
test
To Next Page
Loading...
