SDMO R 340 U - Page 114

In automatic mode
Starting
If faults are present, the fault management screen can be accessed by pressing
Reset.
Refer to the section “Alarms and Faults” in the Operating menus” to
eliminate the faults.
If no faults are present, manual mode can be activated by pressing
A
uto.
In AUTO mode, except for the test functions, the generating set starts as a result of an external command which may be triggered
by various sources:
 power loss
 EJP command (France only)
 client command.
Check there are no faults:
grey: no fault.
red: fault present.
grey: no alarm.
orange: alarm present.
112/285