SDMO R 340 U - Page 282

SPN CID SID PID PPID FMI
John Deere
Volvo
Perkins
Description Comment
1069 Tire size status
2 Tire size error
Not possible with Genset
application
9 Tire size invalid
31 Tire size error
1075 Feed pump of the fuel circuit
5
High impedance at the terminals of the
pump or open circuit
6 Pump coil short to ground
12 Pump defective
1076 Fuel Injection pump status
0 Pump control valve closure too long Injection DE10
1 Pump control valve closure too short Injection DE10
2 Pump detected defect Injection VP44
3 Pump solenoid current high Injection DE10
5 Pump solenoid circuit open Injection DE10
6 Pump solenoid circuit severely shorted Injection DE10
7 Pump control valve closure not detected Injection DE10
10 Pump solenoid circuit moderately shorted Injection DE10
13 Pump current decay time invalid Injection DE10
1077 Fuel injection pump controller status
7 Attempting to fuel without command
11 Pump supply voltage out of range
12 Pump self test error
19 Pump detected communication error
31 Pump initiated engine protection
1078 ECU/Pump timing status
7
ECU/Pump timing moderately out of
synchronisation
11
ECU/Pump timing speed out of
synchronisation
31
ECU/Pump timing extremely out of
synchronisation
1079 232 Sensor supply voltage (+5 Volt) Analog throttle reference
3 Sensor supply voltage high > 5,5 Volt
4 Sensor supply voltage low < 4,44 Volt
1080 211
Sensor supply voltage (Oil pressure, Coolant temp, fuel
pressure)/+5V sensor supply 2
3 Sensor supply voltage high > 5,5 Volt
4 Sensor supply voltage low < 4,40 Volt
1109 Engine/ECU status
31 Engine shutdown warning
1110 Engine status
31 Engine shutdown
1111 268 Check parameters
2 Programmed parameter fault
1136 55 ECU Temperature
0
ECU temperature extremely high
16 ECU temperature moderately high
280/285