Seatex DPS 200 Installation Manual, rev. 4 Introduction
1
1 INTRODUCTION
1.1 About this manual
This manual contains the information necessary to install and set up the DPS 200 equipment
on a vessel. For all other product information, please consult the User’s Manual, reference
[3].
DPS 200 is a very accurate DGPS/DGLONASS positioning sensor. Equipped with two or
more independent DGPS/DGLONASS correction links, increased accuracy and quality
control in the positioning is achieved.
The installation procedures in this manual should be followed in order to achieve the specified
accuracy.
This manual is organised into the following chapters:
Chapter 1 Introduction - A brief presentation of the Installation Manual with references and
abbreviations.
Chapter 2 Specifications - Describes the physical dimensions, required power,
environmental restrictions and cable specifications.
Chapter 3 Installation - Presents procedures to be followed for a typical ship installation
with recommendations on location of the different parts, mechanical and electrical
installation, and how to set up the system.
Chapter 4 Installation Drawings - Contains outline drawings showing the mechanical
dimensions of the different parts in the DPS 200. In addition, it contains a block
diagram including cable list and an antenna mounting drawing.
In this manual the following notations are used:
Is used to make the user aware of procedures and operational practice which, if not
followed, may result in damage to the equipment.
Note A note text has this format and is used to draw the user's attention to special
features or behaviour of the equipment.
CAUTION
To Next Page
Loading...
