Seatex DPS 200 - Default Chapter; Table of Contents

VII
Table of contents
1 INTRODUCTION.............................................................................................................1
1.1 About this manual......................................................................................................1
1.2 References..................................................................................................................2
1.3 Abbreviations and acronyms......................................................................................2
2 SPECIFICATIONS...........................................................................................................3
2.1 Physical dimensions...................................................................................................3
2.2 Power .........................................................................................................................3
2.3 Environmental specification ......................................................................................4
2.4 Radio frequencies.......................................................................................................4
2.5 Cable specification.....................................................................................................4
2.6 Compass safe distance ...............................................................................................5
3 INSTALLATION ..............................................................................................................7
3.1 System components....................................................................................................7
3.2 Logistics.....................................................................................................................8
3.3 Location of the system parts.......................................................................................8
3.3.1 DPS 200 unit ..................................................................................................8
3.3.2 GPS/GLONASS antenna................................................................................9
3.4 DPS 200 cabinet mounting ........................................................................................9
3.5 Installation of coax connectors.................................................................................10
3.6 Antenna and cable mounting....................................................................................14
3.6.1 GPS/GLONASS antenna and cable mounting.............................................14
3.6.2 IALA beacon antenna and cable mounting ..................................................15
3.7 External inputs and outputs......................................................................................16
3.7.1 Connectors....................................................................................................16
3.7.2 Serial lines....................................................................................................17
3.7.3 PPS signal.....................................................................................................19
3.7.4 Connecting procedure...................................................................................20
3.8 Starting the system...................................................................................................21
3.8.1 Configuring COM ports with RS-232 and RS-422......................................21
3.9 Editing setup file......................................................................................................22
3.9.1 Selecting target.............................................................................................23
3.9.2 Datum...........................................................................................................23
3.9.3 Output telegrams ..........................................................................................24
3.9.4 Time and position precision.........................................................................37
3.9.5 Output mode and interval.............................................................................37
3.9.6 UTM mode and zone....................................................................................37
3.9.7 Satellite and fix computation related settings ..............................................38
3.9.8 Height aiding................................................................................................38
3.9.9 Range and age limit on reference stations....................................................39
3.9.10 Differential correction settings.....................................................................39
3.9.11 Handling of corrections (from Fugro Starfix Plus) ......................................39
3.9.12 Offsets in reference station co-ordinates......................................................40
FSP ref.: A11213500XRBRA0