Seatex DPS 200 - Output Mode and Interval; Time and Position Precision; UTM Mode and Zone

Seatex DPS 200 Installation Manual, rev. 4 Installation
37
3.9.4 Time and position precision
It is possible to configure the numbers of decimals in the time and position telegrams.
TIME_PRECISION makes it possible to define the number of decimal digits in the time field
in a telegram. Minimum digit is 0, while maximum is 3.
TIME_PRECISION_1 2
Default is 2.
POSITION_PRECISION makes it possible to define the number of decimal digits in the
position field in a telegram. Minimum digit is 1, while maximum is 6.
POSITION_PRECISION_1 6
Default is 6.
3.9.5 Output mode and interval
It is possible to configure the data telegrams to event-driven or timer-driven output. When
timer-driven mode is selected, the output interval between the telegrams can be decided.
OUTPUTMODE_1 0
OUTPUTINTV_1 1000 [ms]
Default Output Mode is 0, which is event-driven.
Default Output Interval is 1000 ms.
3.9.6 UTM mode and zone
It is possible to specify which UTM mode to use when the telegram ABBDP, which outputs
UTM position, is selected. The following UTM modes are available:
0: Auto extended: zone option is only applicable between 56 degrees to 64 degrees north
and 3 degrees to 6 degrees east. The 32V zone is extended west to 3 degrees east, so
when selecting the Auto extended zone in this area, zone 32V is used. When outside
the current area and Auto extended zone is selected, the used zone is equal to the zone
used when selecting Auto zone.
1: Auto: the system zone is automatically calculated in accordance with the position co-
ordinates.
2: Manual: makes it possible to define which Zone and Zone offset to use. When Manual
mode is selected, UTM zone and UTM zone offset must be specified. The UTM zone
offset option allows a fixed offset to be applied to the longitude degrees. The UTM zone
FSP ref.: A11213500XRBRA0