Overview • 13
17-10-01-266-002a/07-2018B
No. Control Function
1
Change device settings Change settings for operating existing device
2
Add a device Define settings for new seca measuring device
3
Device name Specify the designation of the seca measuring device
4
Timeout Clear patient data
Specify the timeout after which temporarily saved patient data is
discarded.
5
Timeout Transmisson error
Specify the timeout after which the secaconnect 103 assumes that there
has been a communication error with the EMR system.
6
Identification mode Specify patient/user identification
7
Confirm measurement at
device
Specify whether a measurement must be confirmed on the seca
measuring device
8
Server address
Enter the address of the server on which the secaconnect 103 software is
installed
9
Port
Enter port (GPX Listening Port) over which a seca measuring device
should communicate with the secaconnect 103 software
10 QR code for device settings
Scan QR code: Transfer settings to seca measuring device or seca 452
interface module
11 WiFi settings Enter WiFi settings for seca measuring devices
12 QR code for WiFi settings
Scan QR code: Transfer WiFi settings to seca measuring device or
seca 452 interface module
13
save Save settings for the seca measuring device
14 delete device Remove seca measuring device from the device list
To Next Page
Loading...
Need help?
General
