Connecting and installing the seca 452 interface module • 39
17-10-01-266-002a/07-2018B
Preparing the scale 1. Switch off the scale.
2. Disconnect the power supply unit from the power supply socket.
3. Carefully turn the scale over.
4. Pull the power cable out of the scale.
5. Remove the battery block:
a) Press the lid of the battery compartment in the direction of the word
“Battery” printed on the compartment
b) Open the lid
c) Disconnect the battery block from the connector cable
d) Remove the battery block and close the lid again
6. Store the power supply unit and the battery block or dispose of them
properly (➔ Disposal).
To Next Page
Loading...
Need help?
General
