Seca 787 - Page 12

12 •
17-10-07-652-100/05-2019B
4
Tare key
• During the measurement procedure:
- Activate/deactivate
Tare function
•In the menu:
- No function
5
Menu key
• During the measurement procedure:
- Call up menu (press and hold key)
•In the menu:
- Go back one menu level/exit menu (press key briefly)
6
U Hold key
• During the measurement procedure:
- Activate/deactivate Hold function
•In the menu:
- Select menu item, submenu or setting
- Increase value (press and hold key to increase the value more quickly)
7
V BMI key
• If measured values are present:
- Activate
BMI function
•In BMI mode:
- Deactivate
BMI function
•In the menu:
- Select menu item, submenu or setting
- Decrease value (press and hold key to decrease the value more quickly)
8
Confirm key
• If measured values are present:
- Transmit measuring results to an EMR system via
seca connect 103 software
(condition: Active interface module)
•In the menu:
- Confirm selected menu item
- Save set value
9
Workflow LED
Shows the status of data recording and transmission (condition: Active interface module):
• Illuminated in green: Measurement procedure is active
• Flashing green (approx. 5 seconds): Measuring results being sent to the EMR system
(depending on setting)
• Illuminated in green (approx. 5 seconds): Measuring results successfully sent to the
EMR system (depending on setting)
• Illuminated in red (approx. 5 seconds): Error in data transmission or measurement
procedure
NOTE
• The data recorded and transmitted are set in the
seca connect 103 software. If you
have any queries, contact your administrator or hospital technician.
•The
seca 452 external interface module is available as an optional accessory for the
seca 787 measuring station (➔ “Optional accessories (seca 787)”, page 42).
Item Control Function