Secutron MR-2300T User Manual

78
11.8 Clear Event Log (Command-Menu)
Use this menu to clear alarm logs, event logs, or both.
Figure 42 Select Log
1. Select the type of log to clear. Press the ENTER button. The system confirms before
clearing logs.
Figure 43 Clear all the selected logs
2. Press the ENTER button to confirm or the CANCEL button to cancel the operation.
Figure 44 Logs cleared
11.9 Walk Test (Command-Menu)
A walk test allows an installer to verify the initiating circuit wiring in a system. When walk test is
selected, the following screen appears:
Figure 45 Walk test confirmation
Note: Refer to section 11.2.1 on page 64 for detailed instructions on making menu
selections.
Note: Refer to section 11.2.1 on page 64 for detailed instructions on making menu
selections.
i
-Select Log-
1 Alarm Log
2 General Log
3 All Logs
Clear all the
selected log(s)? Y
Log(s) cleared
i
Perform the
walk test? Y

Secutron MR-2300T Specifications

General

Brand	Secutron
Model	MR-2300T
Category	Control Panel
Language	English