89
11.12 Test Dialer (Command-Menu)
11.12.1 Dialer Test Messages
The following messages appear during the test processes of Lines #1 and #2. The messages
that appear depend on the status of the dialer and the test results that are found.
Press Enter to test Line #1. Press Cancel
to exit this menu. For a description of test
messages, see section 11.12.1 below.
Press Enter to test Line #2. Press Cancel
to exit this menu. For a description of test
messages, see section 11.12.1 below.
This feature flushes all reportable events
from the buffer. Press ENTER to reset the
dialer. Press CANCEL to exit this menu.
The dialer is checking the line for voltage. This
message automatically displays when Manual Test is
selected.
No DC line voltage. The line is dead or no phone line
is connected.
The dialer is waiting for a dial tone.
This message may indicate a noisy telephone line.
The dial tone was received and telephone number
dialing is in process.
This message indicates that the dialer failed to send
a DTMF tone.
-Dialer Test-
1. L#1 Manual test
2. L#2 Manual test
3. Reset Dialer
1.L#1 Manual test
2.L#2 Manual test
.
Dialer idle now
No DC Volt
Waiting for Dialtone
Failed: No Dialtone
Dialing Receiver Now
No DTMF tone
To Next Page
Loading...
