EasyManua.ls Logo

Sega Let’s Go ISLAND! - Operation Area

Sega Let’s Go ISLAND!
121 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7
PRECAUTIONS REGARDING INSTALLATION LOCATION
2-2 OPERATION AREA
● Fortheoperationofthismachine,secureaminimumareaof2.62m(103.1in)
widthx2.3m(90.6in)depth.
● SEGAshallnotbeheldresponsiblefordamageorcompensationfordamageto
athirdparty,resultingfromthefailuretoobservethisinstruction.
● Theceilingwherethisproductisinstalledmustbeatleast2.3m(90.6in)high.Ifthe
ceilingistoolow,theheatemittedfromtheproductmaycauseittocatchonre.
● Besuretoprovidesufcientspacespeciedinthismanual.Donotallowobjects
toblocktheventilationports.Itcancausegenerationofheatandare.
● Putthecabinetsclosetogethersothatpeoplecannotgetthroughorprovide
enoughspacebetweenthemthatpeoplecangobothwayswithoutdifculty.
If the cabinets are installed carelessly, people may bump into each other or
the
cabinetswhenpassingbetweenthemorfalldown.Topreventpeoplefrom
walkingbetweenthem,placethem0.15m(5.9in)apart.
● Ifthemachinedoesnottthroughtheentrywaytotheinstallationlocation,
donotdisassembleitwithoutrstconsultingtheinstructions.Specictools
and adjustment procedures are required to assemble and disassemble the
mechanical parts. Attempting to assemble or disassemble the machine without
consulting the instructions may result in accidents during assembly/disassembly
and electric shock, short circuits, and/or personal injury during operation. If the
machine
stilldoesnottthroughtheentrywayafterfollowingtheproceduresin
thismanual,contactyourretailerortheofcelistedinthismanual.
● Ifthemachineisstilltoolargetotthroughtheentrywayafterfollowingthe
procedures listed in this manual, do not tip the machine on its side. Attempting to
transport the machine while it is tipped on its side may cause accidents. It may also
damage or warp parts of the machine, resulting in accidents during operation.
●
To
installthisproduct,theentrancemustbeatleast0.9m(35.4in)inwidthand
1.9m(74.8in)inheight.Iftheentranceistoonarrow,donottilttheproduct
carelessly. If all the product weight is put on the casters at one side only, there
could be damage or deformation, causing serious accidents such as workers
getting caught underneath.
2
2.62 m (103.1 in)
2.3 m (90.6 in)
0.7 m (27.6 in)
0.15 m (5.9 in)

Table of Contents

Related product manuals