84
TROUBLESHOOTING
17
TROUBLESHOOTING
● Thisworkshouldbeperformedbysitemaintenancepersonnelorotherskilled
professionals.Workperformedbynon-technicalpersonnelcancauseasevere
accident such as an electric shock. If there are no site maintenance personnel or
other
skilledprofessionalsavailable,turnthepoweroffimmediatelyandcontact
theofcegiveninthismanualorfromthepointofpurchase.
● Whenworkingwiththeproduct,besuretoturnthepoweroff.Workingwiththe
power on may cause an electric shock or short circuit. When working with the
product, be sure to turn the power off. Working with the power on may cause an
electric shock or short circuit.
● Be
carefulnottodamagethewires.Damagedwiresmaycauseelectricshockor
shortcircuitorpresentarerisk.
● Afterthecauseofcircuitprotectoractivationhasbeenremoved,havethecircuit
protector re-engaged. If the unit is used continuously as is, there could be heat
generation
orre,dependingonthecauseoftheactivation.
● WhenthepowerhasbeenengagedortheTESTMODEhasbeenterminated,
initialization takes place automatically. If anyone is near the product, they could
come in contact or collide with it. Check carefully to be sure that no one is
near
theproductandthatnotoolsoritemshavebeenleftontheproduct,then
engage the power or terminate TEST MODE.
● If
problemsotherthanthosecoveredinthismanualarise,orifnoimprovements
canbenotedaftermeasuresgiveninthismanualhavebeentaken,donot
take measures indiscriminately. Cut off the power immediately and contact the
ofce
showninthismanualorthedealerfromwhomtheproductwasoriginally
purchased. Indiscriminate countermeasures could lead to unforeseeable
accidents. They could also result in permanent damages. Also, if the power
is
leftonwhilethereisanabnormality,are,electricshockorotherserious
accident can occur.
●If
anerrormessageisdisplayed,identifythecauserightawayandtakethe
appropriatecountermeasures.Leavingtheerrorunaddressedcouldresultina
breakdown.
●If
aproblemoccurs,rstinspecttheconnectionofanywiringconnectors.
●StaticelectricityfromyourbodymaydamagesomeelectronicsdevicesontheIC
board. Before handling the IC board, touch a grounded metallic surface so that the
static electricity can be discharged.
17