EasyManuals Logo

Sega Let’s Go ISLAND! User Manual

Sega Let’s Go ISLAND!
121 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #101 background imageLoading...
Page #101 background image
92
ERROR MESSAGE
DISPLAY Error 1001
There is an error in the COIN ASSIGNMENTS SETTINGS.
CAUSE COIN ASSIGNMENTS SETTINGS are incorrect.
COUNTERMEASURES Make sure “SYSTEM TEST MODE” > “COIN ASSIGNMENTS” > “COIN CHUTE
TYPE”
and “SERVICE TYPE” are both set to “COMMON.”
DISPLAY Error 1003
There is an error in the GAME COST SETTINGS.
CAUSE “GAME COST SETTING” is incorrect.
COUNTERMEASURES Check “SYSTEM TEST MODE” > “COIN ASSIGNMENTS” > “GAME COST
SETTING” and make sure the 2P play cost is not set higher than the 1P play cost.
DISPLAY Error 1011-1
CAUSE The 1P “CONTROLLER CALIBRATION SETTING” (X-axis direction) is not
congured properly.
COUNTERMEASURES Refer to 13-1-1 “TOP VOLUME ADJUSTMENT” and adjust the volume. If the
error persists, it is likely a faulty volume. Replace the volume.
DISPLAY Error 1011-2
CAUSE The 2P “CONTROLLER CALIBRATION SETTING” (X-axis direction) is not
congured properly.
COUNTERMEASURES Refer to 13-1-1 “TOP VOLUME ADJUSTMENT” and adjust the volume. If the
error persists, it is likely a faulty volume. Replace the volume.
DISPLAY Error 1012-1
CAUSE The 1P “CONTROLLER CALIBRATION SETTING” (Y-axis direction) is not
congured properly.
COUNTERMEASURES Refer to 13-2-1 “SIDE VOLUME ADJUSTMENT” and adjust the volume. If the
error persists, it is likely a faulty volume. Replace the volume.
DISPLAY Error 1012-2
CAUSE The 2P “CONTROLLER CALIBRATION SETTING” (Y-axis direction) is not
congured properly.
COUNTERMEASURES Refer to 13-2-1 “SIDE VOLUME ADJUSTMENT” and adjust the volume. If the
error persists, it is likely a faulty volume. Replace the volume.
DISPLAY Error 6001
Unable to recognize SEAT MOTOR DRIVE BD.(PITCH)
CAUSE SEAT MOTOR DRIVE BD (PITCH) is not recognized.
COUNTERMEASURES Check to make sure the test works under “GAME TEST MODE” > “CABINET
SETTING” > “SEAT MOTION TEST.”
If the test does not work, check the connection of the wires between the RINGWIDE
and SEAT MOTOR DRIVE BD (PITCH) or replace them. If the test still does not
work after replacing them, it is likely a faulty SEAT MOTOR DRIVE BD (PITCH).
Contact your point of purchase or the ofce listed in this manual.
19

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sega Let’s Go ISLAND! and is the answer not in the manual?

Sega Let’s Go ISLAND! Specifications

General IconGeneral
BrandSega
ModelLet’s Go ISLAND!
CategoryArcade Game Machines
LanguageEnglish

Related product manuals