93
ERROR MESSAGE
DISPLAY Error 6003
The SEAT MOTOR has overheated.(PITCH)
CAUSE The SEAT MOTOR (PITCH) overheated.
COUNTERMEASURES Turn the power off and restart it after the motor temperature drops.
When doing this, remove anything that might obstruct the movement of the seat. If
this error is displayed frequently, it is likely a faulty SEAT MOTOR DRIVE BD
(PITCH) or SEAT MOTOR (PITCH). Contact your point of purchase or the ofce
listed in this manual.
DISPLAY Error 6004
The SEAT MOTOR is using abnormal encoder data.(PITCH)
CAUSE There is an abnormality in the SEAT MOTOR (PITCH) encoder data.
COUNTERMEASURES Make sure all the wires between the front and rear cabinets are connected. If the error
is still displayed after a restart, it is likely a faulty wire between the SEAT MOTOR
DRIVE BD (PITCH) and SEAT MOTOR (PITCH) or a faulty SEAT MOTOR
DRIVE BD (PITCH) or SEAT MOTOR (PITCH). Contact your point of purchase or
the ofce listed in this manual.
DISPLAY Error 6005
An overcurrent has passed through the SEAT MOTOR.(PITCH)
CAUSE There was an overcurrent in the SEAT MOTOR (PITCH).
COUNTERMEASURES If the error is still displayed after a restart, it is likely a faulty SEAT MOTOR DRIVE
BD (PITCH) or SEAT MOTOR (PITCH). Contact your point of purchase or the
ofce listed in this manual.
DISPLAY Error 6009
The SEAT VOLUME is abnormal.(PITCH)
CAUSE There is something wrong with the SEAT VOLUME (PITCH).
COUNTERMEASURES Refer to 14-1-1 “PITCH VOLUME ADJUSTMENT” and adjust the volume. If the
error persists, it is likely a faulty volume. Replace the volume.
DISPLAY Error 6011
Unable to recognize SEAT MOTOR DRIVE BD.(ROLL)
CAUSE The SEAT MOTOR DRIVE BD (ROLL) is not recognized.
COUNTERMEASURES Check to make sure the test works under “GAME TEST MODE” > “CABINET
SETTING” > “SEAT MOTION TEST.”
If the test does not work, check the connection of the wires between the RINGWIDE
and SEAT MOTOR DRIVE BD (ROLL) or replace them. If the test still does not
work after replacing them, it is likely a faulty SEAT MOTOR DRIVE BD (ROLL).
Contact your point of purchase or the ofce listed in this manual.
DISPLAY Error 6013
The SEAT MOTOR has overheated.(ROLL)
CAUSE The SEAT MOTOR (ROLL) overheated.
COUNTERMEASURES Turn the power off and restart it after the motor temperature drops.
When doing this, remove anything that might obstruct the movement of the seat. If
this error is displayed frequently, it is likely a faulty SEAT MOTOR DRIVE BD
(ROLL) or SEAT MOTOR (ROLL). Contact your point of purchase or the ofce
listed in this manual.
19