2P CONT Y Normal if the displayed value changes accordingly when the 2P controller is
moved up and down.
Pointing the controller down decreases the value, while pointing it up
increases the value.
2P CONT TRIGGER_L Normal if the display changes from “OFF” to “ON” when the left trigger on
the 2P controller is pulled.
2P CONT TRIGGER_R Normal if the display changes from “OFF” to “ON” when the right trigger on
the 2P controller is pulled.
2P START BUTTON Normal if the display changes from “OFF” to “ON” when the 2P START
button is pressed.
MOTION STOP Normal if the display changes from “OFF” to “ON” when the MOTION
STOP button is pressed.
TEST Normal if the display changes from “OFF” to “ON” when the switch unit
TEST Button is pressed.
SERVICE Normal if the display changes from “OFF” to “ON” when the switch unit
SERVICE Button is pressed.
SW1 Normal if the display changes from “OFF” to “ON” when the RINGWIDE
TEST Button (SW1) is pressed. (See RINGWIDE service manual.)
SW2 Normal if the display changes from “OFF” to “ON” when the RINGWIDE
SERVICE Button (SW2) is pressed. (See RINGWIDE service manual.)