Sega Let’s Go ISLAND! User Manual

62
CONTROLLER
7
The wires connected to the volume will proceed to be used. Use a tool such as nippers or a cutter to
remove the old heat-shrinkable tubes from the places where the wires are connected.
8
Use a soldering iron to melt the solder and separate the wires from the old volume. Be very careful when
using the soldering iron.
9
If the exposed conductive wire at the end is less than 5 mm, use a tool such as a wire stripper or cutter to
cut the coating back.
10
Pass the wires through the 3 heat-shrinkable tubes.
11
Solder the wires to the terminals on the new volume. Check the wiring diagram and be careful not to mix
up the wires.
12
Cover the soldered parts with the heat-shrinkable tubes and apply heat with an industrial dryer until the
heat-shrinkable tubes tightly cover the soldered parts.
13
Refer to Steps 2 to 6 and work in reverse order to attach the top volume and controller cover.
14
Refer to 13-1-1 “TOP VOLUME ADJUSTMENT” and adjust the top volume.
13

Sega Let’s Go ISLAND! Specifications

General

Brand	Sega
Model	Let’s Go ISLAND!
Category	Arcade Game Machines
Language	English