34 User Manual
Following a Route (Activate the Navigation)
With the Route shown on the Chart page, move the cursor to the starting Way-
point in the Route and press [ENTER], select "GOTO" and press [ENTER] again.
TM11/T-59.09/T-59.05:
move the cursor to the starting Waypoint in the Route and press [GOTO].
The destination is placed on the Waypoint of the selected Route and you are now
navigating to it.
Inserting Waypoint
To insert a new Waypoint between two existing ones:
Place the cursor on the desired Route leg + [Insert]
1
+ move the cursor to
the new position + [ENTER]
1
The new Waypoint is placed.
To add a new Waypoint to the last Waypoint of the Route:
Place the cursor + [ENTER] + "WAYPOINT" + [ENTER]
T-59.05:
Place the cursor + [ROUTE]
NOTE
1
FOR T-59.09, press [1, Insert] and [1, Accept].
Reversing Route
To generate a new route reversing an existing one.
If in Route Data Report page:
[MENU] + "Route" + [ENTER] + "Report" + [ENTER] + [Reverse]
1
The Route is then followed in reverse order, with Waypoints renumbered accordingly.
If the destination is placed on the Route, that Route cannot be reversed.
NOTE
1
FOR T-59.09, press [3, Reverse].
Selecting Route Report page
To give information on Waypoints belonging to the selected Route:
[MENU] + "Route" + [ENTER] + "Report" + [ENTER]
In this page it is possible to modify the Speed and Fuel consumption values:
[MENU] + "Route" + [ENTER] + "Report" + [ENTER] + [Speed]
1
/[Fuel]
1
+
use the cursor to insert values + [ENTER]
NOTE
1
FOR T-59.09, press [1, Fuel]/[2, Speed].
Sending Route
To transmit the Active Route information onto the NMEA output port.
[MENU] + "Route" + [ENTER] + "Send" + [ENTER]
The NMEA WPL & RTE messages are sent to the output port.
Receiving Route
To save Route information received from the NMEA input port.
[MENU] + "Route" + [ENTER] + "Receive" + [ENTER]
The received route is saved on the Active route, overwriting it. The NMEA WPL &
RTE messages are sent to the input port.
Safe Route Checking
This function checks the presence of particular cartographic objects (see the list
below) on a range set by the user for all Route legs:
♦ Land Areas
♦ Shallow Water
To Next Page
Loading...