86 User Manual
5.6.12 Alarms Menu
The Alarms menu allows you to define additional sonar alarm settings for Fish
Alarm, Shallow Alarm, Depth Alarm and Temperature Upper/Lower/Rate.
[MENU] + "Alarms" + [ENTER]
Shallow Water : Triggers an alarm when depth becomes shallower than the value set.
Deep Water : Triggers an alarm when depth becomes deeper than the value set.
High Water Temp : Triggers an alarm when the transducer reports a temperature (from TEMP 1 sensor) above the
value set.
Low Water Temp : Triggers an alarm when the transducer reports a temperature (from TEMP 1 sensor) below the
value set.
Water Temp Rate : Triggers an alarm when the transducer reports a temperature (from TEMP 1 sensor) variation rate
above the value set.
Fish Alarm : The options for Fish Alarm set the size of the fishes that, if detected by the unit, switches an alarm
to sound. These options are: Off, Small, Medium, Big and Huge. The alarm sounds if the set size
(or bigger) is detected.
5.6.13 Save & Load Menu
Insert the USER MEDIA into the slot, then follow the procedure:
[MENU] + "Save & Load" + [ENTER]
Load Settings from USER MEDIA: Load the complete settings from the USER MEDIA and changes the active menu
settings.
Save Settings to USER MEDIA : This is useful to avoid the user having to retune up Fish Finder after a Clear RAM
operation or a software update.
Restore Current Preset Defaults : Restores the default values only for the current presets (see Par. 5.6.1, Preset
Mode) and does not affect the other presets.
5.7 TRANSDUCERS
The transducer is a device that transmits and receives sound waves into the
water. The active component inside the transducer is commonly referred to as an
element but actually is a piezoelectric ceramic material.
Please refer to your dealer and/or installer to choose your transducer. Techmarine
suggest transducers.
To Next Page
Loading...