Selco NEOMIG 2000 - GUIDE TABLE FOR WELDING PARAMETERS; Parameter Selection by Wire Diameter and Application; Shielding Gas Selection and Usage

8 TECHNICAL SPECIFICATIONS
NEOMIG 1600 NEOMIG 2000 NEOMIG 2200 NEOMIG 2400
Power supply voltage (50/60 Hz) 1x230Vac -20+10% 3x230/400Vac -20+10% 1x230Vac -20+10% 3x230/400Vac -20+10%
Delayed line fuse 16A @ 230Vac 16A @ 230Vac 32A @ 230Vac 16A @ 230Vac
10A @ 400Vac (*) 16A @ 400Vac
Maximum power absorbed 6.3 KVA 8.5 KVA 11 KVA 10.1 KVA
Power factor 0.9 0.9 0.9 0.9
MIG welding current (40°C)
(x=20%) 140A 200A 220A -
(x=30%) - - - 240A
(x=60%) 80A 130A 130A 170A
(x=100%) 60A 100A 100A 130A
Adjustment range 30A/15.5V 30A/15.5V 30A/15.5V 30A/15.5V
140A/21V 200A/24V 220A/25V 240A/26V
1x7 pos. 1x10 pos. 1x10 pos. 1x10 pos.
Loadless voltage 34.5Vdc 38.5Vdc 38.5Vdc 41Vdc
Gearmotor power 40W (2 rollers) 40W (2 rollers) 40W (2 rollers) 40W (2 rollers)
Wire diameter 0.6 ÷ 1 mm 0.6 ÷ 1.2 mm 0.6 ÷ 1.2 mm 0.6 ÷ 1.2 mm
Wire feed speed 1.5 ÷ 18 m/min 1.5 ÷ 18 m/min 1.5 ÷ 18 m/min 1.5 ÷ 18 m/min
Wire feed button yes yes yes yes
Gas bleed button yes yes yes yes
Synergy no (N 2000 XP) no (N 2400 XP)
Steel rollers yes yes yes yes
Protection rating IP21S IP21S IP21S IP21S
Insulation class HHHH
Construction standards EN 60974-1 EN 60974-1 EN 60974-1 EN 60974-1
EN 60974-5 EN 60974-5 EN 60974-5 EN 60974-5
EN 60974-10 EN 60974-10 EN 60974-10 EN 60974-10
Dimensions (lxdxh) 500x913x750 mm 500x913x750 mm 500x913x750 mm 500x913x750 mm
Weight 47 Kg. 48 Kg. 66 Kg. 58 Kg.
Power supply cable 3x2.5 mmq 4x2.5 mmq 3x4 mmq 4x2.5 mmq
Data at 40°C ambient temperature
*For the Neomig 2200 systems you are advised to use 32A thermal magnetic protection devices with characteristics for
inductive loads.
26