Operation
Hardware Setup
Version 1.0 Operation 3-1
Chapter 3
The iCon™ APX Advanced Functionality Meter is configured using the iConFig™ application.
This chapter provides brief descriptions of the Modules used to configure the meter.
Refer to iConFig Start-up and User’s Guide for instructions on configuring the meter.
Hardware Setup
The information in this section is not intended to provide instructions to unqualified personnel
nor replace the extensive training needed to safely handle the metering equipment. The set-up of
all meters shall be accomplished by qualified electricians and metering specialists.
The procedures described in this section are recommended for new or upgraded meters. After
setting up the meters, it may be necessary to program/reprogram and/or calibrate the meter.
The set-up of all meters shall be accomplished by qualified electricians and metering specialists.
All Meters
In order to insure security, the meters are protected by two seals.
• A T-Bar Seal that goes on the back of the meter
• Demand Reset Seal that secures the RESET/ALT Lever.
After set-up is complete, seal the meters.
To Next Page
Loading...
Need help?
General
