2.1
SECTION 2 INSTALLATION – GENERAL
2.1 Introduction
This section provides all the information required to install the 2500 analyser. The
installer is advised to read this section through completely before commencing the
installation.
2.2 Preparation
2.2.1 Tools
Installation of the 2500 requires the use of standard hand tools only, and an Allen key
provided with the instrument to open the end case covers. Preparation of suitable
mounting holes in support brackets or panels may require appropriate power tools.
2.2.2 Safety Precautions
The electrical power used in this equipment is at a voltage high enough to endanger
life therefore normal electrical safety precautions must be observed. Where necessary
a warning is placed prior to the procedure it refers to as shown in the following example:
2.2.3 Unpacking and Inspection
Lift in the approved manner and remove the 2500 analyser from its packing and inspect
for any damage incurred during transit. If any damage has occurred inform Servomex
or their agents immediately. Retain packing, in case it is required to return the analyser
to the supplier.
WARNING
Always ensure that the electrical mains power supply is disconnected before
commencing work.
WARNING
Electrostatic hazard: Clean display and keypad using a clean cloth moistened
with water.
WARNING
2500 analysers weigh at least 25 kg (55 lb) and care must be taken when
handling. Use 2 people if necessary and only lift using the yellow handles
provided, not the sample cell.
To Next Page
Loading...
Need help?
General
