8.1
SECTION 8 CE MARKING AND OTHER SAFETY APPROVALS
All 2500, 2510 and 2550 Analysers are CE marked and comply with all appropriate
European Community Directives.
8.1 EMC Directive
Electromagnetic Compatibility Directive 89/336/EEC (as amended by 92/31/EEC and
93/68/EEC) by the application of the following standard:
EN 61326: 1997 +A1: 1998 +A2: 2001 Calling:
Emissions; Table 4, Class B. Equipment used in establishments directly
connected to a low voltage supply which supplies buildings for domestic
purposes;
Immunity: Table A1 Industrial Environments.
8.2 Low Voltage Directive
Low Voltage Directive 73/23/EEC and the CE Marking Directive 93/68/EEC by the
application of the following standards:
EN 61010-1 (equivalent to IEC 61010-1)
Safety requirements for electrical equipment for measurement, control and
laboratory use – general requirements:
2500, 2510 and 2550 Analysers are rated in accordance with:
IEC 60664 for Installation Category II, which is characterised as being local level (i.e.
not distribution level), appliances and portable equipment with over-voltage impulse
withstand up to 2500V.
8.3 Pressure Directive
All the relevant design aspects of the 2500 series analysers have been assessed in
respect of the requirements of the Pressure Equipment Directive (97/23/EC). These
products are excluded from the scope of this directive when installed and operated
within their published specifications.
NOTE
Assessment under the Low Voltage Directive is not required for CE marking if the
equipment is approved under the ATEX Directive for use in potentially explosive
atmospheres
To Next Page
Loading...
Need help?
General
