Sevcon Clearview - Introduction to Clearview Display

Doc. 177/5250x
Rev A
2-2
Introduction
The Display is a configurable CANopen display which can be set up to show a variety of data
from the Sevcon motor controllers it is connected to. It can also be used to configure
parameters on the controllers. It has the following features:
 320x240, 256 colour display.
 Auto-baud rate detection.
 Configurable main screen.
 Configurable screen list.
 Single and multi-node support.
 Reads/writes a wide range of commonly used vehicle system settings.
 Displays I/O + motor/vehicle status information
 Displays any active faults and provides basic diagnostic information.
 Displays a historical fault log for any fault on the motor controller system.
 Fully flash programmable for display software updates.