Sevcon Clearview - Splash Screen and Data Acquisition

Display Usage
Doc. 177/5250x
Rev. A
5-3
power cycles the display will start at the detected baud rate, and the system will start up
normally.
During the power on process, the splash screen is displayed. Power on progress is displayed
on the bottom of this screen.
Splash Screen
The default splash image is shown below.
This product is produced as a generic product. If you require a custom splash image for your
application, contact your local Sevcon representative to discuss.
Acquisition of Displayed Data
The display can acquire the data that it displays either using the CANopen SDO protocol, or
using the CANopen PDO protocol. By default, the display will generate SDO upload requests
for any data item displayed but if an RPDO has been configured on the display to handle
that data item, then no SDO request will be generated, and the display will only show the
data that has been received in PDO messages.
Please contact Sevcon for assistance with configuring RPDOs on the display.
Figure 3 Splash Screen