Doc. 177/5250x
Rev A
6-4
First Screen
The first screen after power on can be selected. Once the Splash screen / power on process
is complete, the display will go to the chosen screen as the first screen to show. This is
configured using an object dictionary item as shown below:
Object Index 0x2807 Description Value
Sub 0 First screen
0 = Main
1 = System Overview
2 = Vehicle Status
3 = Time to Distance
4 = Personalities
5 = Configuration
6 = Test
7 = Fault History
The first screen can also be selected through the Configuration screen, by using the Display
Initial Screen parameter. The values to select are as above.
The setting will take effect after the next power cycle.
To Next Page
Loading...