Doc. 177/5250x
Rev A
6-2
Display CAN bus Node ID.
Node ID when Connected to a System
The display is designed to be connected to a variety of different vehicle combinations, and
does not have a fixed node id.
The node id is set to be 10 greater than the highest node id that was discovered.
For example, if connected to a 3 node system that has 3 motor controllers as nodes 1, 2 and
3, the display will have node id 13.
Node ID when Standalone
If the display is powered up standalone, the node id will default to 35.
To Next Page
Loading...