Doc. 177/5250x
Rev A
5-6
Figure 6 – System Overview
This screen displays information about the currently connected nodes, and the state of the
nodes. The primary function is to show any active faults that are present.
The screen is split into two halves:
Top half shows the list of nodes that are currently connected, and if any faults are
active on the node.
Bottom half shows detailed fault information for the node that is selected with the
highlight bar.
The up and down buttons move the highlight bar between nodes on the top half of the
screen.
Where there are multiple faults active for a node, the number of faults is given as a count in
the bottom half of the screen. Each of these faults can then be viewed by pressing the enter
button to cycle round the faults.
The screen is updated in real time. If a fault is set or cleared on the system, the information
on the screen will be updated automatically.
To Next Page
Loading...